ما

Boron Removal Adsorbent - search results

Adsorption Study for Removal of Boron Using Ion …

removal of boron from effluent. In the present study, removal of boron from synthetic boric acid solutions containing high concentrations of boron by adsorption over an anion exchange resin (Amberlite IRA 743) was investigated on a batch basis. The effects of various process parameters on boron removal in terms of adsorption capacity were ...

ادامه مطلب

Removal of boron from water using adsorbents derived from ...

In addition, different adsorbents have been designed specifically for removal of boron from water such as activated carbon [ 6 ], chitosan [ 7 ], and granular activated carbon [ 8 ]; achieving more than 90% removal of boron from water. The effect of parameters on boron removal through ion-exchange membrane was studied [ 9] and found that the ...

ادامه مطلب

Adsorption potential of unmodified rice husk for boron removal

To observe the effect of adsorbent dosage on boron removal, different amounts of rice husk were used (1.0, 2.0, 3.0, 4.0, 5.0, and 6.0 grams). The pH of the solution was adjusted to the desired level with 1M NaOH and 1M HCl solutions for pH 5 up to 10.

ادامه مطلب

(PDF) Preparation, Characterization and Adsorption Study ...

The percentage removal of COD and boron under selected operating conditions (30 to 120 min and 5 g/L adsorbent dosage) are shown in Fig. 4 and 5. It was found that COD and Boron removal efficiencies increased with an increase from 100 to 300 rpm.

ادامه مطلب

Boron removal from wastewater using adsorbents. - Abstract ...

The removal of boron from the above-described wastewater was examined in the static (batch) and dynamic (column) experiments. The static experiments were carried out to assess boron adsorption isotherms, based on which the most efficient adsorbent as …

ادامه مطلب

Boron Removal from Wastewater Using Adsorbents | Request PDF

The boron adsorption capacity and percentage removal from the solution containing 50 mg B L−1 amounted to 2.3 mg g−1 and 93%, respectively, while pH 7, adsorption time = 0.5 h, and adsorbent ...

ادامه مطلب

(PDF) Microcrystalline cellulose (MCC) as an adsorbent in ...

Adsorbents to Remove Metals, Dyes and Boron from Polluted Water ed In amuddin et al. (Cham: Springer Inte rnational Publishing) pp 113 – 42 [15] Mosur …

ادامه مطلب

(PDF) Removal of boron from ceramic industry wastewater by ...

In recent development, the addition of borates in the profuse sources of POMB bottom ash at low cost make it to be ceramic tile bodies can lower the energy usage and greatly an economic choice of adsorbent for boron removal in enhance the mechanical strength of the products (Tamir- industrial wastewater treatment.

ادامه مطلب

Removal of Boron from Aqueous Solutions by Adsorption ...

alumina could be also a suitable adsorbent for the removal of boron from water. The adsorption was strongly dependent on pH, adsorbent dose and boron concentration. For initial concentration of 5 and 50 ppm, the maximum uptake of boron reaches respectively …

ادامه مطلب

Boron removal from water by adsorption onto activated ...

Boron is one of the elements most problematic in water. There does not exist any effective method for its elimination. Main processes that have been studied for boron removal are chemical precipitation, adsorption (Lyu et al. 2017), reverse osmosis (Dydo et al. 2012) and electrodialysis.Among these methods, an adsorption method is promising for the boron removal …

ادامه مطلب

Boron Removal by Adsorption on Cobalt(II) Doped Chitosan ...

for boron removal from water and wastewater with com-paratively low boron content (up to 100 mg/L) is adsorption using inexpensive, environmental-friendly and abundant materials characterised by high affinity for orthoboric acid [8–10]. Many adsorbents such as fly ashes (FAs) [1113–], modified clays and zeolites [14, 15], some inorganic materi-

ادامه مطلب

Methods for boron removal from aqueous solutions — A ...

The technology commonly used for the removal of boron from aqueous solutions, the application of chelating resin, seems to be one of the most effective methods .It was shown that chelating resins containing ligands having three or more hydroxyl groups, located in the cis position, the so-called "Vis-diols", show a high selectivity to boron while these groups are not reactive to ordinary ...

ادامه مطلب

Boron adsorbent - Watch-Water

Boron Removal with. Trappsorb & Crystolite. Boron. often detected in natural water streams and have a wide variety of concentration depending on surrounding geology and sewage disposal. The importance of micronutrient of. Boron. can be harmful when exceed permittable concentration. Boron. is widely distributed in surface water, ground water and can

ادامه مطلب

An updated review on boron removal from water through ...

12%The boron contamination in surface water will eventually lead to the elevation of boron concentration in drinking water source and also a life threat to aquatic ecosystem. This highlights the significance of boron remediation from water. The adsorption by chelating adsorbents for boron removal is effective to some extent.

ادامه مطلب

Boron Adsorption-Desorption by Steelmaking Slag for Boron ...

Polat et al. attributed boron removal to the nature of the material used as boron adsorbent and the working conditions (pH, external solution/adsorbent ratio, equilibration time). Specifically, it is reported that boron adsorption by fly ash was higher when pH was higher than 9.0, external solution/adsorbent ratio was lower than 20, and ...

ادامه مطلب

[PDF] Boron removal from industrial wastewaters by means ...

The results showed that temperature, pH and mass of adsorbent affected boron removal by adsorption, and Boron removal increased with increasing pH and advertisersorbent dosage, but decreased with increasing temperature. Expand. 120. View 1 excerpt, references methods; Save. Alert.

ادامه مطلب

RADIATION GRAFTED NANOFIBROUS ADSORBENT …

boron selective resin such as Amberlite IRA743 (6.7 mg/g). The results of this study suggest that the adopted preparation procedure is highly effective in preparation of nanofibrous adsorbents with the desired content of boron selective ligands. Moreover, the adsorbent was proven to have a strong potential for application in boron removal

ادامه مطلب

Boron Removal by Adsorption on Cobalt(II) Doped Chitosan ...

The new adsorbent Co-CTS can be interesting in surface water treatment to remove boron because of non-toxicity, bacteriostatic and fungistatic properties. The big advantage is the ease of Co-CTS regeneration with 0.01 M NaOH and nearly efficiency ratio of adsorption–desorption.

ادامه مطلب

Water | Free Full-Text | New Technology for Degradation of ...

The existing boron removal technologies include adsorption, precipitation, reverse osmosis, ion exchange, adsorption membrane filtration (AMF), and chemical oxygen precipitation (COP) [8,12,13,14,15,16,17,18,19]. Due to the various chemical structures and variable amounts of boron existing in water, such boron can hardly be removed in a simple ...

ادامه مطلب

ADSORPTION POTENTIAL OF UNMODIFIED RICE HUSK FOR BORON ...

Boron removal was increased with an increasing amount of adsorbent dosage but decreased as the initial concentration of adsorbate increased. A Freundlich isotherm was used to describe the potential of boron adsorption using rice husk. The maximum adsorption capacity of rice husk was found to be 4.23 mg/g for boron removal.

ادامه مطلب

Removal of Fluorine and Boron From Groundwater Using ...

The results indicated that it was possible for the adsorbent to remove more than 95% of boron and fluorine from the groundwater, and that the performance of the adsorbent for boron removal was better than commonly used ion-exchange resin. The adsorbent used several times was able to remove boron, indicating that the adsorbent can be used for ...

ادامه مطلب

AmberLite™ PWA10 - DuPont

AmberLite™ PWA10 Ion Exchange Resin is a unique drinking water grade, macroporous resin designed for the removal of boron from drinking water. The resin can be regenerated using a two-step process consisting of a regeneration step to displace the boron followed by a conversion step.

ادامه مطلب

A new adsorbent for boron removal from aqueous solutions ...

It was found that the removal of boron increased while the adsorbent dose increased and the temperature decreased at an optimum pH (pH=8) and a contact time of 30 min. At optimum conditions, the maximum boron percentage removal was 75%. According to the D–R model, the maximum capacity was estimated to be>3 mg B/g of the adsorbent.

ادامه مطلب

Recent advances in adsorption and coagulation for boron ...

The boron-spiked streams are produced from coal-fired and geothermal power plants, the manufacturing and the activities of oil/gas excavation and mining. The adsorbents for boron removal are classified into the ones functionalized by chelating groups, the ones on the basis of …

ادامه مطلب

(PDF) An updated review on boron removal from water ...

Boron removal from aqueous solutions by adsorption — A review By Paola Barreto Breakthrough modelling of glucamine functionalized PVDF nanofibrous adsorbent in a fixed-bed column for separation of boron from water

ادامه مطلب

Boron removal from aqueous solutions using alginate gel ...

A column sorption study was carried out using calcium alginate gel beads as adsorbent for the removal of boron from aqueous solutions. The breakthrough curve was obtained as a function of pH, initial concentration of boron, feed flow rate, adsorbent mass and column diameter.

ادامه مطلب

Boron - Removal - Watch-Water

to adsorb Boron in the Boron-Concentrated-Water to remove Boron. The treatment process and this unique process is the main contention of this literaturepreparation. WATCH WATER ® High Quality Adsorbent. Water. Technology & Chemicals. Boron . Removal. Continuesfrompreviouspage… Boron. Removal. In the Katalox-Light treatment the Boron ...

ادامه مطلب

Boron Removal from Aqueous Solution Using Curcumin ...

EFFECT OF ADSORBENT DOSE The removal of boron was increased as the adsorbent dose increased because of the increase in the total available surface area of the adsorbent particles (Figure 4). For the initial concentration of 1000 mg/L, the uptake of boron reached up to 55% for a Cur-AC compared with 35% for bare AC. The effectiveness of boron ...

ادامه مطلب

Activated boron nitride as an effective adsorbent for ...

Novel activated boron nitride (BN) as an effective adsorbent for pollutants in water and air has been reported in the present work. The activated BN …

ادامه مطلب

Removing boron from wastewater - Finishing

We have used peat for boron removal, in the first stage we compared four kinds of adsorbents Basalt, peat,compost and activated carbon and we found peat is the best. the result of this part of our study will be published in journal of environmental technology "INVESTIGATION OF ORGANIC, INORGANIC AND SYNTHETIC ADSORBENTS FOR THE PRE TREATMENT OF ...

ادامه مطلب